高速臺鉆具有多種用途，工零星和成批生產手表、儀器、量具、電訊器材、照相電影器材等用，特別適用印制板電路小孔加工。

Speed bench drill has applications in odd or lot production of parts of parts of watches,instruments,measuring tools,telecommunication eguipments, photoraphic and cinematic equipments etc,and especially suitable for drilling fine holes on printed circuits.

徐州店朱小姐0516-85020665 18951358764

技術參數：

鉆削范圍Drilling capacity：                                 0.6-6mm

主軸最大手動行程Maximum manua travel of spindle：            60mm                      

主軸頭最大垂直行程Maximum shift tvavel of spindle：            90mm

主軸軸線至立柱表面距離Distance from the axis of spindle to the surface of column：145mm

主軸端錐度（莫氏1a短錐）Spindle cone(Morse taper 1a shors cone)：B10

主軸端面至底座工作面最大距離Maximum distance between the spindle nose to working：225mm

主軸轉速Speed of the spindle：                               1500,3000,6000,12000r/min

主軸精度Precisionspindle：                                         0.01mm

底座工作面尺寸Dimensions fo working surface of the base：        250×230mm

電動機380V三相50赫茲0.3千瓦2800轉/分Motor 380V 3Ph 50Hz 0.37Kw 2800r/min

凈重（包括電機）Net weight(including motor)：                  ≈46Kg

外形尺寸（長×寬×高）Overall dimensions(L×W×H)：         560×270×530mm

使用

Operating

1. 本機床主軸箱的升降采用絲桿螺母機構。在調整主軸箱的位置時，應先用升降鎖緊手柄（1）松開升降塊（3），再用升降鎖緊手柄搖動升降螺桿使主軸箱升（或降）之所需要的位置，然后再將升降鎖緊。

Lead screw and nut are used for lifting and lowering the spindle head . In adjusting the position of spindle head ,locking biock(1)must be loosed with the handie(3)first, then lift or lower the spindle head to desired position through turning the handle after fit it back on the top pod of the lead screw,and lock up the locking block finally.

1. 本機床采用標尺定深機構。定深時可先轉動粗調旋鈕（5）調至所要的位置，然后轉動細調旋鈕（7）進行細調。

A staff gauge is used to control the depth of drilling hole .The drilling depth

Can be abjusted by coarse adjusting knob (5)and fine abjusting knob(7)one after another.

1. 平皮帶松緊的調節，應先松開緊定螺絲（2）,推動電機機座底板，使皮帶松或緊到需要的程度，然后在擰緊緊定螺釘。

In adjusting the tension of belt, loose the screw(2)first,then push or pull the base plate of motor, and tighten up the scrow finally.

1. 主軸的變速是靠調換平皮帶的位置獲得的。

Various speeds of the spindle are resulted from changing the positiong of belt on them.